With the wide application of LEDs, LED heat dissipation issues are getting more and more attention. The thermal performance of LED will directly affect the life of LED products. Therefore, it is imperative to solve the problem of LED heat dissipation. This paper analyzes the misunderstandings of LED heat dissipation and shares some countermeasures about LED heat dissipation. I hope it will help everyone.
First, the analysis of the misunderstanding of LED heat dissipation
The misunderstanding of LED heat dissipation is mainly reflected in the following aspects:
1. The internal quantum efficiency is not high. That is, when electrons and holes recombine, photons cannot be generated 100%, and it is generally called "current leakage" to lower the recombination rate of carriers in the PN region. Multiplying the leakage current by the voltage is the power of this part, which is converted into heat, but this part is not the main component, because the internal photon efficiency is now close to 90%.
2. The internally generated photons cannot be completely emitted to the outside of the chip and finally converted into heat. This part is the main one, because the current external quantum efficiency is only about 30%, and most of it is converted into heat.
3. Over-reliance on thermally conductive materials. Because of the high-tech materials used, the heat can be dissipated. Its practical ordinary aluminum heat dissipation, after repeated tests, the temperature of the heat sink is only 3-5 degrees Celsius higher than the bottom of the radiator. That is to say, if a material with excellent thermal conductivity can be used, the temperature can be lowered by 3-5 degrees Celsius when the thermal resistance is zero.
4. Superstition heat pipe. The heat pipe has a good thermal conductivity, which is beyond doubt. But the heat that is derived from the heat sink eventually needs to go tropical through air convection. If there are no fins that dissipate heat, the heat pipe will soon reach thermal equilibrium and the temperature will rise with the heat sink. If you add heat sink fins to the heat pipe, you will eventually use fins to dissipate heat. Moreover, the contact points of the fins and the heat pipes are not as good as other methods. The result is a high cost and no improvement in heat dissipation. However, it is useful to use heat pipes on integrated LEDs, but it must be structurally sound!
5. Believe in the nano-radiation materials promoted by some manufacturers. Radiation heat dissipation is negligible in the current temperature of LED lamps at around 50 degrees Celsius. The radiation coatings promoted by the manufacturers have a good radiation effect even if they are advertised, even if they reach the radiation capacity of black body radiation, the heat dissipation proportion is only a few percent. Moreover, the coating itself hinders the heat transfer, which affects the heat dissipation of the convection.
100 Watt Led Flood Lights Outdoor are DLC 4.3 Qualified and ETL-Listed, making them eligible for many utility, local, state, and federal LED retrofit rebates! 100 Watt LED Flood Light saves money, saves energy, and is rewarded in your energy efficient choice.The Flood Lights have an IP66 Rating which means that there`s complete protection against dust and powerful water jets.
100 watt Led Flood Lights Outdoor
100 Watt Led Flood Lights Outdoor,100 Watt Led Flood Light,Flood Lights
Shenzhen Bbier Lighting Co., Ltd , https://www.chinabbier.com